Solar Panel Charger Controller Regulator 10A 12V/24V

The product can automatically manage the work of Solar Panel and battery in Solar System, which is below 120W (12V) or below 240W (24V).

Function:

• Over-load protection
• Short circuit protection
• Protection from the lightning strike
• Under-voltage protection
• Over-charging protection

Connection:

• Connect the "+", "-" poles of the battery to the correct ports of controller (the third and the fourth one from left)
• If load indicator (mark: load) flickers once and starts lighting after 30 seconds, you can tell the connection is correct and proceed the following operation.
• Connect the "+", "-" poles of the solar panel to the correct ports of controller (the first and the second one from left)
• Connect the "+", "-" poles of the load to the correct ports of controller (the fifth and the sixth one from left)

Indicator LED:

• The lighting of Charge LED means the battery is being charged strongly; Flickering means the battery is in floating charge mode; Off means charging stopped
• The lighting of Load LED means there is output and load can work; Off means there isn't output and the load cannot work

Notice:

• Make sure the rated voltage of solar panels, batteries and loads are same and are all 12V or all 24V
• The rated current of solar panels and load must be less than the rated current of controller

Specifications:

• Rated Voltage: 12V or 24V
• Rated Charging Current: 10A
• Rated Load Current: 10A
• Working Temperature: -20 - +60℃
• Dimension (L x W x H): Approx. 101 x 95 x 35 mm
• Quantity: 1

Keywords: Controller, charger, regulator, solar panels, solar panel charger